Colop Make 1 Stamp Pad 90x50mm Fancy Grey

Description

A Colop Make 1 Stamp Pad 90x50mm Fancy Grey like this small one is what you need to use a traditional stamp that is quite small.

Open the lid.  Dab your stamp around on the surface of the stamp pad to ink up and then onto your paper.  Close the lid when you are finished so there are no accidental inking incidents.

It is as easy as that to use a stamp pad.

• Pre-inked with stamp ink ready to use classic stamp pad
• Ink will stay useable for years
• Great to use with our hand stamps

This ink pad is 50 x 90mm internally.

We find that a stamp needs to be smaller than each dimension to get in here.  There is usually a bit of the body of the stamp sticking out further than the rubber stamp part.  Also to allow some maneuverability so you can dab the stamp a few times in different places to get enough ink on the rubber for a good print.

For our custom hand stamps we recommend no taller than 45mm or no wider than 85mm to use in this ink pad.  To get these inked well you need to get the stamp inside the little raised edge and in full contact across the surface of the stamp to get the best print from a stamp.

How to make the best mark on paper with a hand stamp and ink pad.

To get the best mark from your stamp we recommend slowing down.  Do not rush your mark.  Ink the stamp well by dabbing a few times in the ink pad before going to the paper.

Time and pressure is required to transfer the ink well from the rubber die of the stamp to the paper.  It is imperative to ensure all areas of the stamp have pressure applied to the paper area.  Using a flat plate type of stamp like our Custom Hand Stamp you will need to use a circular action of pressure to the handle of the stamp to apply pressure around the outside edge of the stamp to make sure every part of the stamp makes contact with the paper.

Do not allow the edge of the stamp to lift during that action as this can produce a second mark and blur the image mark on paper.

Also make sure the surface being stamped on is absolutely flat.  With a slightly soft surface.  Sometimes around 10 pages of paper can give enough flex to obtain a higher quality mark on your paper.

To see the other stamp ink pads available click HERE.

This ink pad is from Colop the makers of the Colop Printer range of self-inking stamps.